Contents

Thermophysics and Aeromechanics

Vol. 32, No. 2, 2025

Carbon formation during partial oxidation of methane under conditions of high pressures (review)

A.V. Shishkin p. 267

Study of thermophysical parameters of new-generation “green” hydrocarbon fuel for reusable aerospace systems

L.S. Yanovskiy, G.A. Tarasov, V.M. Ezhov, M.A. Il’ina, N.A. Chervonnaya, and D.V. Novakovskiy p. 297

Thermal conductivity and thermal diffusivity of magnesium-lithium alloys

A.Sh. Agazhanov, R.N. Abdullaev, D.A. Samoshkin, and V.A. Nepomnyashchikh p. 303

Determination of the amplitude-frequency characteristics of the system consisting of a hot-wire anemometer and a sensor on the basis of the laser pulse: methodology improve-ment

D.A. Bountin and O.I. Vishnyakov p. 311

Hydrodynamics and heat transfer of a laminar jet impinging on a catalytic surface

V.V. Lukashov, V.V. Lemanov, A.V. Tupikin, V.A. Fedorenko, and K.A. Sharov p. 315

Heat transfer enhancement in an impinging jet with a fractal grid at the inlet

S.N. Yakovenko p. 321

Investigation of the dynamics of large eddies in the near zone of an axisymmetric free jet in the case with local pulsed injection in the coaxial and transverse directions

M.I. Sorokin, D.A. Kushnarev, M.P. Tokarev, and V.M. Dulin p. 327

Thermal calculation of the heating block of a high-pressure direct contact heater based on an experimental study

F.A. Svyatkin, V.D. Lychakov, Y.V. Usov, A.S. Matyash, B.F. Balunov, Yu.G. Sukhorukov and P.V. Egorov p. 333

Numerical simulation of film cooling with coolant supply through a nozzle of triangular shape with a step

N.N. Kozyulin and M.Yu. Hrebtov p. 339

Slowing down and acceleration of gas combustion fronts while two-spark initiation

V.S. Teslenko, A.P. Drozhzhin and Yu.V. Anisichkin p. 355

Direct numerical simulation for puffs in tubes with various lengths

V.A. Ivashchenko and R.I. Mullyadzhanov p. 367

Assessment of the film existence boundary position on an air streamed surface for a problem of airfoil icing

A.V. Kashevarov and A.L. Stasenko p. 373

Comparison of two-dimensional and three-dimensional models of wave rivulet flow over an inclined plane

S.P. Aktershev, V.V. Guzanov, A.Z. Kvon, A.V. Bobylev, and A.V. Cherdantsev p. 383

Effect of a constant magnetic field on a supersonic flow near a submillimeter pulsed electric discharge

M.A. Yadrenkin, Yu.V. Gromyko, and O.I. Vishnyakov p. 395

Influence of the particle collision model on the heat fluxes in a rarefied gas computed by the Direct Simulation Monte Carlo method

M.Yu. Plotnikov and E.V. Shkarupa p. 405

Modeling of chemically nonequilibrium separated flows in the HyCFS software system

T.Yu. Shkredov and G.V. Shoe p. 415

The possibility of using liquid biofuels with additives of vegetable oils and fatty acid esters

G.V. Kuznetsov, D.S. Romanov, and P.A. Strizhak p. 435

Enhancing the stability of physics-informed neural networks applied to convection problems

Ch.A. Tsgoev, M.A. Bratenkov, D.I. Sakharov, V.A. Travnikov, A.V. Seredkin, V.A. Kalinin, D.V. Fomichev, and R.I. Mullyadzhanov p. 449

Effect of the thermo-solutal buoyancy on the Poiseuille –Taylor– Couette fluid flow

S. Khali, L. Nasseri, and D.E. Ameziani p. 465

Modeling of heat transfer in rotating hollow cylinders using thermal resistance

R. Mehryar, S. Momtazi, and N. Rezaei p. 485

Irreversibility analysis of Jeffrey fluid mixed convection flow through a sloping channel under the influence of angled magnetic

M. Ravi and K. Kaladhar p. 509

Multiscale hydrodynamics in wedge-platform thrust bearing with rough surface

X.Y. Shao and Y.B. Zhang p. 531