Vol. 52, No. 5, 2018
A simultaneous English language translation of this journal is available from Pleiades Publishing, Ltd.
Distributed worldwide by Springer. Theoretical Foundations of Chemical Engineering ISSN 0040-5795.
Layered Three-Dimensional Nonuniform Viscous Incompressible Flows
p. 765 abstract
Energy Savings in Flowsheets based on Combination of Distillation and Splitting Processes
p. 771 abstract
Mathematical Modeling of Operation of a Reactor with Flow-Through Three-Dimensional Electrodes at the Limiting Diffusion Current under Non-Steady-State Conditions
p. 779 abstract
Multicomponent Fuzzy Model for Evaluating the Energy Efficiency of Chemical and Power Engineering Processes of Drying of the Multilayer Mass of Phosphorite Pellets
p. 786 abstract
Regeneration of Chromium Electroplating Electrolytes by the Application of Electromembrane Processes
p. 800 abstract
Thermal Processing of Dripping Substances in a Capsular Envelope Submerged in a Boiling Liquid in a Vacuum
p. 806 abstract
Optimal Heat Transfer during the Change of Phase State of a Refrigerating Medium
p. 812 abstract
Fine Purification of Substances by Countercurrent Sublimation
p. 819 abstract
Factorial Analysis of the Kinetics of Radical Polymerization of Methyl Methacrylate
p. 825 abstract
Investigation of Catalytic Activity of Modified High-Silica Zeolite of MFI Type in the Process of Converting Straight-Run Gasoline
p. 832 abstract
HCl Neutralization by Alkaline Sorbents in the Gasification of Chloride-Containing Fuel in the Filtration Combustion Mode
p. 837 abstract
Calculating the Parameters of the Fractal Aggregates Formed in a Bidisperse Suspension
p. 846 abstract
Comparative Thermohydraulic Efficiency of Processes in Channels with Chaotic Packing
p. 853 abstract
Phase Equilibria in the Sodium-Acetate–Sodium-Formate–Water System at Temperatures of from 0 to –22°C and the Anti-icing Properties of Compositions Based on These Salts
p. 859 abstract
Forming Porous Structures on Silicon with a Ferroelectric for Capacitive Microelectronic and Microsystems Engineering Elements
p. 862 abstract
The Phase Formation and Microstructure of Composites Based on 3Ti–Al with Addition of В4С Obtained by the Powder Metallurgy Method
p. 868 abstract
Optical Properties and Radiation Resistance of Zinc Orthosilicate Obtained by the Hydrothermal–Microwave Method
p. 873 abstract
Preparation of Fine-Grained Corundum Powders with Given Properties: Crystal Size and Habit Control
p. 879 abstract
Forming a Nanocomposite Medium-Based Cascade Solar Cell Structure
p. 887 abstract
Interphase Distribution of Aromatic Acids in the Polyethylene Glycol–Sodium Sulfate–Water System
p. 890 abstract
Peroxide-Assisted Oxidative Desulfurization of Nonhydrotreated Vacuum Gas Oil
p. 894 abstract
Use of Machining to Increase the Recovery of Scandium from Refractory Silicate Raw Material
p. 898 abstract
Optimizing the Technology of Titanium Phosphate Adsorbent Synthesis from Sulfate-Containing Titanium(IV) Solutions
p. 903 abstract
On Complex Processing of the Khovu-Aksy Dumps
p. 909 abstract
Fine Purification of Rhenium to Remove Polyanions during Selective Desorption from a Strongly Basic Anion Exchanger in Schemes for Obtaining Ammonium Perrhenate
p. 912 abstract
Removal of Impurities from Saturated Ion-Exchange Resins by Frontal-Gradient Purification in Schemes for Recovery of Nonferrous, Rare, and Rare Earth Metals
p. 920 abstract