Contents
Steel in Translation
Vol. 39, No. 6, 2009
Simultaneous English language translation of the journal is available from Allerton Press, Inc.
Distributed worldwide by Springer. Steel in Translation ISSN 0967-0912.
Oxygen-Converter Reduction of Iron and Manganese from Their Oxides
by Components Dissolved in Liquid Iron
M. K. Shakirov, I. A. Zhibinova, K. M. Shakirov, and E. V. Protopopov p. 445 abstract
Calculation of Gas-Powder Injection Units Using Models of Two-Speed Flow
E. V. Protopopov, T. R. Galiullin, A. G. Chernyatevich, and P. S. Kharlashin p. 450 abstract
Improving the Rolling of Rails
S. V. Dorofeev, V. V. Dorofeev, A. B. Yurev, V. E. Gromov, and V. N. Peretyatko p. 454 abstract
Deformable Heatproof Transeutectic Silumin for Pistons
A. N. Prudnikov p. 456 abstract
Utilization of Oxidized Cast-Iron and Steel Scrap in Small-Diameter Shaft Furnaces
A. V. Feoktistov, I. F. Selyanin, S. A. Bedarev, A. V. Prokhorenko, and V. A. Marchenko p. 460 abstract
Influence of the Grain Size of Fe3.25% Si Polycrystalline Alloy
on Twinning over a Broad Range of Temperature and Strain Rate
V. A. Fedorov, T. N. Pluzhnikova, A. M. Kirillov, and D. E. Dolgikh p. 463 abstract
Carbidization of Titanium Alloys in Electroexplosive Carburization
and Additional Heat Treatment
A. V. Vostretsova, S. V. Karpii, E. A. Budovskikh, V. F. Goryushkin, and V. E. Gromov p. 466 abstract
Coke Quality for Blast Furnaces with Coal-Dust Fuel
Yu. A. Zolotukhin and N. S. Andreichikov p. 470 abstract
Coal Gasification as an Alternative to Natural Gas
A. I. Pavlov p. 475 abstract
Blast-Furnace Charging with a Lobed Batch Distributor
E. G. Donskov, V. P. Lyalyuk, V. I. Ilchenko, G. P. Kostenko, and E. E. Donskov p. 479 abstract
Improving the Continuous Casting of Rail Steel
A. B. Yurev, L. A. Godik, N. A. Kozyrev, and N. M. Sapaev p. 486 abstract
Automated Dimensional Monitoring of Hot Continuous-Cast Billet
A. V. Anikin, I. P. Ierusalimov, and Yu. N. Karfidov p. 489 abstract
Smelting Pure X15C
-B Electrosteel with Ferroalloy Diversification
M. I. Gasik, A. I. Panchenko, L. M. Skripka, A. S. Salnikov, and S. L. Mazuruk p. 491 abstract
Low-Ash Reducing Agents in Electrical Heating of Silicoaluminum
A. N. Glazatov, A. Yu. Baimakov, M. R. Rusakov, and A. M. Saltykov p. 495 abstract
Improvements to Rolling on Broad-Strip Mills
A. I. Starikov, A. G. Medvedev, V. N. Nemtsev, and K. A. Medvedev p. 498 abstract
Effective Production of Large Pipe Blanks
O. A. Kobelev, A. V. Zinovev, and M. A. Tsepin p. 501 abstract
Mandrel Calibration and Optimization of Deformation Source in Piercing Mill
S. R. Rakhmanov and V. N. Danchenko p. 506 abstract
Lubricants for Dry Wire Drawing
A. A. Trukhanovich and A. A. Ledneva p. 510 abstract
Drawplate Manufacture Using an Electrospark Cutting Tool
A. B. Solyanikov, E. Yu. Prein, T. V. Koshurnikova, and P. N. Smirnov p. 512 abstract
Standardizing the Annealing of Metal Rolled on Reversible
and Four-Cell Mills in Dome Furnaces
T. P. Poletskova, Yu. P. Demidchenko, S. G. Andreev, N. I. Malova, and V. N. Gorbulin p. 516 abstract
Improving the Magnetic Properties of 2NSR Amorphous Alloy
B. A. Kornienko and E. V. Artamonov p. 518 abstract
Enrichment by X-ray Radiometric Separation
E. F. Tsypin, V. S. Shemyakin, S. V. Skopov, Yu. O. Fedorov,
V. V. Pestov, and E. V. Entaltsev p. 521 abstract
Pleiades Publishing home page | journal home page | top
If you have any problems with this server, contact webmaster.