Vol. 61, No. 6, 2020
Direct Reduction of Heavy Nonferrous Metals from Sulfide Compounds
p. 601 abstract
Positron Annihilation Studies of Modified Aluminide Coatings on Nickel and Nickel Superalloy
p. 608 abstract
Short Fluoride Cycle in Tungsten Technology
p. 615 abstract
Magnetic Structure and Nanomechanical Properties of Sintered Permanent Magnets Nd–Dy–Fe–B USC-20L
p. 623 abstract
Synthesis of Aluminum Alloys from Dispersed Waste Based on Aluminum
p. 632 abstract
Influence of Rolling and Annealing Modes on Properties of Sheet Semifinished Products Made of Wrought Aluminum Alloy 1580
p. 641 abstract
Studying the Influence of Radial-Shear Rolling on Thermal Deformation Conditions of A1050 Processing
p. 646 abstract
Effect of Rolling Process on Microstructures and Mechanical Properties of High Strain-Rate Rolled ZK60 Magnesium Alloy
p. 658 abstract
Chemical Composition and Structure of Interfacial Boundaries in Cr3C2–Ti Powder Hard Alloys after Explosive Compaction and Subsequent Heating
p. 667 abstract
Self-Propagating High-Temperature Synthesis of Silicon Carbide Nanofibers
p. 675 abstract
Synthesis of Inorganic Cobalt-Containing Spinel-Type Pigments by Self-Propagating Synthesis
p. 680 abstract
The Possibility of Dense Materials Based on Obtaining an AlN–SiC Solid Solution by Self-Propagating High-Temperature Synthesis Gasostating
p. 686 abstract
Synthesis Features, Structure, and Properties of Promising High-Temperature Ceramics in the Hf–Ta–B–Ti–Si System
p. 691 abstract
Structure, Properties, and Oxidation Resistance of Prospective HfB2–SiC Based Ceramics
p. 704 abstract
Synthesis of Porous Composite Material with the Combustion of Titanium and Boron Powders and Nickel-Clad Aluminum Granules
p. 716 abstract
Synthesis of Nanoporous Ceramic Materials for the Filtration of Liquids and Gases by the Technological Combustion Method
p. 725 abstract
Mechanical Properties and Heat Resistance of Ta–Zr–Si–B–C–N Coatings Obtained upon the Magnetron Sputtering of the TaZrSiB Target in Ar, N2, and C2H4 Atmosphere
p. 732 abstract
Experimental and Computational Determination of the Wear Resistant Coefficient for Coatings with Nanodispersed Carbide Particles Added by Laser Surfacing
p. 739 abstract
Optimization of Characteristics of Pyrolytic Chromium Carbide Coatings
p. 745 abstract
Investigation of the Processes of the Formation of a Nonequilibrium Phase-Structural State in FeTiB Films Obtained by Magnetron Sputtering
p. 753 abstract
Effect of Sodium Silicate Concentration on Morphology of Ceramic Coatings Produced on Commercially Pure Aluminum Using Plasma Electrolytic Oxidation
p. 762 abstract