Contents
Russian Engineering Research

Vol. 34, No. 6, 2014

A simultaneous English language translation of this journal is available from Allerton Press, Inc.
Distributed worldwide by Springer. Russian Engineering Research ISSN 1068-798X.

Maximum Height of an Obstacle Overcome by a Wheeled Vehicle

G. I. Mamiti, S. Kh. Pliev, and E. K. Gutiev p. 351  abstract

Relation between the Fluctuations in Hole Shape and Position before and after Reaming

S. G. Andreeva, G. S. Zheleznov, and V. G. Krutsilo p. 353  abstract

Optimal Ram Extrusion of Wood–Plastic Composites

A. N. Ekimenko p. 357  abstract

Predicting the Life of Chain Transmissions

S. A. Metil’kov and S. B. Berezhnoi p. 362  abstract

Theoretical Aspects of Technological Mechanics. 9. Strain and Accumulated Strain. Part 1

A. L. Vorontsov p. 366  abstract

Geometric Shaping in Cutting

Yu. E. Petukhov, N. V. Kolesov, and S. Yu. Yurasov p. 374  abstract

Predicting the Limiting State of a Multiblade Hard-Alloy Tool

E. G. Krylov and A. V. Belova p. 381  abstract

Surface Plastic Deformation of an Applied Metal Layer

V. A. Korotkov p. 386  abstract

A Methodological Error in Analyzing the Forces within a Frictional Pair

I. K. Aleksandrov p. 389  abstract

Dynamic Characteristics of the Supporting System in a Horizontal-Drilling Machine

Yu. V. Kirilin and E. A. Spiridonov p. 393  abstract

High-Efficiency Axial Cutting Tools

Yu. P. Burochkin p. 396  abstract

Quality Control in the Production of Metal-Cutting Tools

Yu. I. Rudometov p. 400  abstract

Determining the Maximum-Performance Temperature of Hard-Alloy Cutting Plates

E. V. Artamonov, D. S. Vasilega, and A. M. Tveryakov p. 402  abstract

Determining the Optimal Cutting Speed in Turning by Composite Cutters
on the Basis of the Chip

E. V. Artamonov and D. V. Vasil’ev p. 404  abstract

Compensation of the Pitch Errors in Helical Gears

A. N. Vasin, B. M. Iznairov, and G. Kh. Mukatova p. 406  abstract

Influence of the Heat Transfer in the Finishing of High-Speed Steel
on the Residual-Stress Distribution

F. Ya. Barats and A. V. Kochetkov p. 410  abstract

Mathematical Models of the Axial Cutting Forces in the Broaching
of Structural Carbon and Alloy Steel

Yu. N. Seleznev, V. S. Gubanov, A. S. Rukhlin, and L. V. Khoroshilova p. 414  abstract

Special-Purpose Equipment

V. M. Vorob’ev p. 417  abstract

Surface-Layer Quality after High-Speed Turning of Hard Material

I. E. Kiryushin, D. E. Kiryushin, S. B. Venig, T. G. Nasad, M. O. Stepanova, and D. V. Terin p.423  abstract

Pleiades Publishing home page | journal home page | top

If you have any problems with this server, contact webmaster.