Contents
Russian Engineering Research
Vol. 33, No. 4, 2013
A simultaneous English language translation of this journal is available from Allerton Press, Inc.
Distributed worldwide by Springer. Russian Engineering Research ISSN 1068-798X.
Technological Inheritance in Vehicles Frictional Systems
I. A. Medelyaev p. 185 abstract
StressStrain State of Slotted Grips
D. S. Blinov and A. A. Shatilov p. 188 abstract
Repulsive Forces of Highly Coercive Permanent Magnets in Magnetic Clutches
and Plane Magnetic Systems
A. Ya. Krasilnikov and A. A. Krasilnikov p. 194 abstract
Natural Wear and Design of Frictional Components in Piston Engines
V. A. Kochenov p. 197 abstract
More Efficient Profiling and Use of Diamond Grinding Wheels
Sh. A. Bakhtiarov, V. V. Volkov, Yu. N. Abubekerova, and A. G. Tudoska p. 203 abstract
Theoretical Aspects of Technological Mechanics: 1. Fundamentals of Continuum Mechanics
A. L. Vorontsov p. 206 abstract
Increasing the Strength of Threaded Components by Prior Plastic Deformation of the Metal
O. V. Gerasimova and V. Ya. Gerasimov p. 211 abstract
Influence of Coatings on the Antiskip Properties of Slipping Guides
M. A. Levantsevich, N. N. Maksimchenko, and V. N. Kalach p. 213 abstract
Benefits of Ceramic Cutters in Turning Hard Steel
V. N. Puchkin, A. A. Ryzhkin, V. A. Kokhanovskii, M. M. Aliev, L. A. Solonenko,
T. V. Kononeko, and V. M. Terekhov p. 217 abstract
Adaptive Optimization of the Planned Tool Life with Scheduled and Preventive Tool Replacement
N. I. Pasko and P. P. Shilov p. 222 abstract
Optimization of Automated Parameter Measurements for Airplane Components
A. Yu. Popov, V. A. Sergeev, D. S. Rechenko, E. S. Rechenko, and M. A. Rechenko p. 225 abstract
Support Inclination in Centerless Grinding of Conical Surfaces
B. M. Brzhozovskii and O. V. Zakharov p. 227 abstract
Predicting the Surface Microrelief of Press-Mold Components in Abrasive Grinding
Ya. I. Soler and V. V. Lgalov p. 229 abstract
Ultrasonic Stimulation in Thread Cutting
V. G. Shuvaev and V. A. Papshev p. 236 abstract
Discontinuous and Composite Grinding Wheels in Bilateral Face Grinding of Thin-Walled Blanks
A. D. Evstigneev p. 238 abstract
Determining the Contact Zone in Disk Machining of a Complex Spherical Mill
N. A. Chemborisov, I. Z. Sungatov, and R. M. Khisamutdinov p. 243 abstract
Thread Cutting on Parts with a Discontinuous Surface
A. V. Fomin and E. V. Fomin p. 244 abstract
A Tool for Machining Shafts and Applying an Antifrictional Coating
V. M. Sorokin, S. S. Tanchuk, V. A. Zotova, A. V. Mikheev, V. V. Berglezov, and V. V. Mikheev p.247 abstract
Pleiades Publishing home page | journal home page | top
If you have any problems with this server, contact webmaster.