Contents

Russian Engineering Research


Vol. 37, No. 2, 2017

A simultaneous English language translation of this journal is available from Pleiades Publishing, Ltd.
Distributed worldwide by Springer. Russian Engineering Research ISSN 1068-798X.


Axisymmetric Control Valve for Oil and Gas Equipment

I. N. Karelin p. 87  abstract

Energy-Saving Modular Electric Furnaces with Energy Recuperation

A. I. Nizhegorodov p. 91  abstract

Determining the Elastic Modulus of a Hard Coating from the Loading Curve in Indentation

N. A. Voronin p. 97  abstract

Damping Characteristics of Cable-Based Dampers and Hydraulic Bearings

B. A. Gordeev, S. N. Okhulkov and P. A. Zlobin p. 103  abstract

Drawing of Two-Layer Axisymmetric Anisotropic Components with Wall Thinning

S. S. Yakovlev, M. V. Gryazev and O. V. Pilipenko p. 110  abstract

Edge Forces in Machining by Abrasive Brushes

Yu. V. Dimov and D. B. Podashev p. 117  abstract

Programmable End Milling of Thermoplastics

A. A. Emel’yanenko, O. I. Zhabin and Yu. N. Polyanchikov p. 122  abstract

Cutting Characteristics in the End Milling of Stainless Steel

S. V. Grubyi p. 125  abstract

Verifying the Geometric Precision of Machine Tools

R. R. Kadyrov and R. G. Kudoyarov p. 134  abstract

Modernization of Numerically Controlled Machine Tools on Modular Principles

V. V. Platonov, E. V. Platonova and I. G. Maizel’ p. 140  abstract

Wear Resistance of Hard-Alloy Disk Mills with Different Flank Geometry

N. Yu. Kovelenov, S. V. Bolotskikh, S. V. Mikhailov and A. S. Mikhailov p. 144  abstract

Hard-Alloy Metal-Cutting Tool for the Finishing of Hard Materials

D. S. Rechenko, A. Yu. Popov, D. Yu. Belan and A. A. Kuznetsov p. 148  abstract

Simulation of Grinding with Wear of the Abrasive Grains

D. V. Ardashev and L. V. Shipulin p. 150  abstract

Influence of the Boundary Conditions on the Forces in the Abrasive Machining of Rubber

A. M. Khanov, L. D. Sirotenko, L. P. Shingel’, E. V. Matygullina, E. O. Trofimov and A. A. Drozdov p. 154  abstract

Attractive Manifolds in End Milling

V. L. Zakovorotny, A. A. Gubanova and A. D. Lukyanov p. 158  abstract

Continuum Design of Grinding Operations

D. V. Ardashev and V. I. Guzeev p. 164  abstract

Factors Affecting the Angular Velocity of the Workpiece in Abrasive Finishing

K. R. Muratov, E. A. Gashev and D. M. Lagunov p. 167  abstract