Contents
Russian Engineering Research


Vol. 33, No. 12, 2013

A simultaneous English language translation of this journal is available from Allerton Press, Inc.
Distributed worldwide by Springer. Russian Engineering Research ISSN 1068-798X.


Selecting the Mechanical Parameters of an Inspection Device for Oil and Gas Lines

V. I. Shcherbakov and D. V. Aksenov p. 679  abstract

Stress Concentration in Symmetric Two-Arm Crank with Transverse Flexure

V. B. Bulanov, I. E. Semenov-Ezhov, and A. A. Shirshov p. 683  abstract

Analysis of Torsional Crankshaft Oscillations in a Diesel Engine on the Basis
of Cylinder-Block Vibration

V. N. Nikishin, A. P. Pavlenko, K. N. Svetlichnyi, and V. S. Gol’makov p. 687  abstract

Frictional Cladding by Means of a Flexible Tool

N. N. Maksimchenko p. 692  abstract

Mechanochemical Formation of Tungsten Carbide from Plant-Derived Carbon

D. V. Onishchenko, V. V. Chakov, and V. V. Petrov p. 697  abstract

Theoretical Aspects of Technological Mechanics.
7. Axisymmetric Problems in Plasticity Theory. Part 1

A. L. Vorontsov p. 702  abstract

Multipurpose Lathes with Expanded Capabilities

O. K. Akmaev and B. A. Enikeev p. 710  abstract

Drive Diagnostics in Metalworking Machines in Terms of the Machined-Surface Parameters

Yu. V. Idrisova, R. G. Kudoyarov, and S. I. Fetsak p. 714  abstract

Permanent-Magnet Shaft Bearing for High-Speed Spindles

A. A. Gerasin, F. R. Ismagilov, I. Kh. Khairullin, and V. E. Vavilov p. 718  abstract

Predictive Assessment of the Operational Efficiency of Hard-Alloy Tools

V. V. Postnov, S. V. Starovoitov, and S. Kh. Khadiullin p. 723  abstract

Increasing the Life of Coated High-Speed Steel Tools

V. M. Kishurov, V. N. Ippolitov, and M. V. Kishurov p. 727  abstract

Predicting the Machining Precision in End Milling

R. R. Basharov and R. G. Kudoyarov p. 731  abstract

Thermal Dissipation of Mechanical Energy in Turning Hard Materials

E. N. Malakhov, A. Yu. Fedorovtsev, and S. Kh. Khadiullin p. 736  abstract

Improved Manufacture of Complex Turbine Components by Automated Machining

A. M. Smyslov and O. V. Kolenchenko p. 741  abstract

Geometric Monitoring of Gas-Turbine Rotor Blades in Metalworking

V. V. Postnov, P. P. Chernikov, and I. S. Zmeeva p.744  abstract


Pleiades Publishing home page | journal home page | top

If you have any problems with this server, contact webmaster.