Contents
Russian Engineering Research

Vol. 34, No. 11, 2014

A simultaneous English language translation of this journal is available from Allerton Press, Inc.
Distributed worldwide by Springer. Russian Engineering Research ISSN 1068-798X.

Multilayer Piezoelectric Nano- and Micromotors with a Transverse Piezo Effect

S. M. Afonin p. 671  abstract

Load Distribution between Hob Teeth

G. G. Skrebnev and A. S. Anan’ev p. 680  abstract

Properties of Reinforced Antifrictional Epoxy–Fluoroplastic Materials

D. V. Otmakhov and S. P. Zakharychev p. 687  abstract

Wear Resistance of Die Steels after Plasma Quenching

V. A. Korotkov and N. V. Zlokazov p. 691  abstract

Morphology of Copper Powder Produced by Electrospark Dispersion from Waste

E. V. Ageeva, N. M. Khor’yakova, and E. V. Ageev p. 694  abstract

Frame Models of Structural Elements in an Automated System for Tool Selection

L. A. Simonova and B. E. Egorov p. 697  abstract

Structure of the Library of Parametric Gear-Cutter Models in the KOMPAS system

A. V. Shchekin, E. V. Mitin, and S. P. Sul’din p. 701  abstract

A New Pass-Through Lathe Cutter

N. S. Dudak, G. T. Itybaeva, Zh. K. Musina, A. Zh. Kasenov, and A. Zh. Taskarina p. 705  abstract

Distribution of Alloying Elements between Nonmetallic Carbide Phases
in Nitrided Cutting Ceramic

T. V. Kononenko, V. N. Puchkin, A. A. Ryzhkin, M. M. Aliev, and L. A. Solonenko p. 708  abstract

Algorithm for Calculating the Parameters of the Initial Blank
in the SITEP MO Automated Design System

S. Yu. Kalyakulin p. 713  abstract

Chip Metallography in Disk-Saw Cutting of Hot-Rolled Steel

A. I. Bannikov, N. A. Dyatlov, I. L. Permyakov, and A. S. Antonov p. 716  abstract

Cut-Layer Cross Section in Oblique Turning

A. V. Filippov p. 718  abstract

Influence of Axial Harmonic Oscillations on Chip Formation
when Drilling Holes in Ductile Metals

A. V. Maslennikov, S. A. Chevychelov, M. S. Merzhoeva, M. Sh. Gatiev, and V. V. Sidorova p. 722  abstract

Continuous Chip as a Mesomechanical Factor Destabilizing the Cutting Process
in Heavy Manufacturing

B. Ya. Mokritskii and V. V. Altukhova p. 725  abstract

Abrasive Finishing of Brittle Materials

A. M. Khanov, K. R. Muratov, R. A. Muratov, and E. A. Gashev p. 730  abstract

Automated Filling of Flexible Containers with Free-Flowing Products

A. M. Makarov, Yu. P. Serdobintsev, and E. G. Krylov p.734  abstract

Pleiades Publishing home page | journal home page | top

If you have any problems with this server, contact webmaster.