Vol. 94, No. 12, 2023
On the Possibility of Introducing an Integrated Starter–Generator into a Gas-Turbine Engine Body
p. 883 abstract
On the Prospects for Using a Dual-Phase Magnetic Material to Increase the Specific Power of an Autonomous Generator
p. 888 abstract
Mathematical Modeling of Barrier Discharge
p. 893 abstract
A Cooling Jacket Design for a Starter–Generator Body
p. 896 abstract
An Analysis of the Influence of Radial Magnetic-Bearing Design on Magnetic Characteristics
p. 900 abstract
Methods of Balancing Phase Currents in Multiphase Step-Down DC Converters
p. 906 abstract
Permanent-Magnet Machines as Aircraft Integrated Starter–Generators
p. 913 abstract
Calculation of the Propeller Group for a Drone in Takeoff Mode
p. 918 abstract
Design of Electric Motors for Unmanned Aerial Vehicles
p. 922 abstract
Improvement of Aviation Electric-Generator Cooling Efficiency by Means of Thermoelectric Converters
p. 925 abstract
On the Mechanical Strength of Rotors with a Dual-Phase Magnetic Material
p. 931 abstract
Challenges and Prospects of Development of Power Supply for Electrotechnological Induction–Heating Equipment
p. 936 abstract
On the Fire Safety of Electric-Vehicle Battery Packs
p. 942 abstract
The Effect of Transformer-Oil Aging on the Residual Service Life of the Transformer and Its Diagnostic Parameters
p. 947 abstract
Modeling of the Overhead-Line Mode Using Long-Line Equations Taking into Account Corona Losses
p. 955 abstract
Assessment of Submersible Electric-Motor Reliability
p. 961 abstract