Contents

The Physics of Metals and Metallography

Vol. 121, No. 4, 2020

Electrical and Magnetic Properties

Magnetic Nanoparticles as a Strong Contributor to the Biocompatibility of Ferrogels

F. A. Blyakhman, E. B. Makarova, P. A. Shabadrov, F. A. Fadeyev, T. F. Shklyar, A. P. Safronov, S. V. Komogortsev and G. V. Kurlyandskaya p. 299  abstract

Study of Phase Transitions in the Antiferromagnetic Heisenberg Model on a Body-Centered Cubic Lattice by Monte Carlo Simulation

A. K. Murtazaev, F. A. Kassan-Ogly, M. K. Ramazanov and K. Sh. Murtazaev p. 305  abstract

Spin-Reorientation Transitions in Multiferroics with Cycloidal Spin Ordering

Z. V. Gareeva, L. A. Kalyakin, I. R. Kayumov and A. K. Zvezdin p. 310  abstract

Stress-Induced Magnetic Anisotropy Enabling Engineering of Magnetic Softness GMI Effect and Domain Wall Dynamics of Amorphous Microwires

V. Zhukova, P. Corte-Leon, L. González-Legarreta, M. Ipatov, A. Talaat, J. M. Blanco, J. Gonzalez, J. Olivera and A. Zhukov p. 316  abstract

Structure, Phase Transformations, and Diffusion

Investigation of Cyclic Oxidation Behavior of (Cr, Mo, Si)-Containing (α2 + γ) TiAl-Based Alloys Synthesized by ECAS Sintering

Y. Garip and O. Ozdemir p. 322  abstract

Deformation-Induced Atomic Disordering and bcc → fcc Transformation in Heusler Alloy Ni54Mn21Ga25 Subjected to Megaplastic Deformation by High Pressure Torsion

V. G. Pushin, N. N. Kuranova, E. B. Marchenkova and A. V. Pushin p. 330  abstract

Composite Structure as a Strengthening Factor of Stainless Austenitic Chromium–Nickel Additive Steel

M. V. Staritsyn, P. A. Kuznetsov, S. N. Petrov and M. S. Mikhailov p. 337  abstract

Annealing-Induced Structural–Phase Transformations in an Al–Zn–Mg–Fe–Ni Alloy after High Pressure Torsion

I. G. Shirinkina and I. G. Brodova p. 344  abstract

Observation of the Martensitic-Austenitic Component in the Structure of Low-Carbon Low-Alloy Pipe Steel

I. L. Yakovleva, N. A. Tereshchenko and N. V. Urtsev p. 352  abstract

Analysis of the Microstructure, Phase Composition, and Oxidation Kinetics of Heat-Resistant Titanium Alloys with Gadolinium

A. A. Popov, M. O. Leder, M. C. Karabanalov, E. N. Popova and I. V. Narygina p. 359  abstract

Structure, Phase Composition, and Mechanical Properties of Biocompatible Titanium Alloys of Different Types

A. G. Illarionov, A. G. Nezhdanov, S. I. Stepanov, G. Muller-Kamskii and A. A. Popov p. 367  abstract

Strength and Plasticity

Microstructure Analysis and Optimization of Parameters for Improved Properties in High Strength AA8079 (Al–Fe–Cu–Si–Zn)

M. Meignanamoorthy and M. Ravichandran p. 374  abstract

Effects of Growth Rate on Eutectic Spacing, Microhardness, and Ultimate Tensile Strength in the Al–Cu–Ti Eutectic Alloy

Ümit Bayram and Necmettin Maraşlı p. 382  abstract

Dynamic Strength of Submicrocrystalline and Nanocrystalline Copper Obtained by High-Strain-Rate Deformation

I. V. Khomskaya, S. V. Razorenov, G. V. Garkushin, E. V. Shorokhov and D. N. Abdullina p. 391  abstract

Changes in the Mechanical Properties of High-Chromium Economically Alloyed Pipe Steel Depending on Tempering Conditions after Intercritical Quenching

A. N. Makovetskii, D. A. Mirzaev, L. I. Yusupova, A. O. Krasnotalov, A. A. Mirzoev and S. A. Sozykin p. 398  abstract