Vol. 50, No. 7, 2021
A simultaneous English language translation of this journal is available from Pleiades Publishing, Ltd.
Distributed worldwide by Springer. Journal of Machinery Manufacture and Reliability ISSN 1052-6188.
The Possibility of Using a System with an Inertial Element as an Impact Damper
p. 569 abstract
Developing a Calculation Technique for Thermoelastic Rods under Dynamic Loading
p. 575 abstract
Studying Stiff Dynamic Systems with the Example of Simulation of a Tape Transport Mechanism
p. 584 abstract
The Question of Impact Dynamics of the Elementary Cutting Blade of the Rotor on the Soil
p. 590 abstract
Determining the Residual Stresses upon Penetration by a Spherical Indentor
p. 595 abstract
Conditions for the Existence of the R-State in the TiNi-Based Alloy
p. 601 abstract
Real-Time Adaptive Control Based on a Reinforced Learning Neural Network
p. 605 abstract
Classification and Analysis of Additive Technologies Based on the Morphological Approach
p. 616 abstract
Simplified Computer Simulation and Analysis of the Stress–Strain State of a Hip Joint Endoprosthesis Made of Carbon–Carbon Composite Material in an Elastic Medium
p. 622 abstract
Information System on the Properties of Hydrocarbons and Their Derivatives (ISHD)
p. 630 abstract
Automation of Information Processing in the Intelligent System of Marine Monitoring
p. 634 abstract
Automation of Sawing Using New Crank-Type Equipment
p. 642 abstract
Evaluation of the Efficiency of Engineered Ammunition When Breaching the Bureya River Stream Channel and Proposals for Improvement
p. 651 abstract